• Secure payment

Active filters

Reference: MT619

Brand: MicroTec

CAN Test Box (CTB)

Review(s): 0
The CAN Test Box gives you easy access to the 16 pins of the diagnostic connector that is fitted to all modern vehicles. Depending on the configuration of the vehicle, this may allow you to check power, ground and CAN Bus signal quality. With the test adaptors supplied you can connect your PicoScope automotive scope, or any other suitable scope, to the...
kr869.00 tax excl.
kr1,086.25 tax incl.
More
In stock, shipped today

Reference: MI074

Brand: Pico Technology

Secondary ignition pickup (capacitive with BNC)

Review(s): 0
Due to the high voltages involved in secondary ignition systems, it is not possible to make measurements by direct connection. Attempting to make a direct connection will almost certainly damage the measuring instrument. The MI074 is a capacitive pickup that simply connects around the insulation of an ignition circuit component such as a plug wire. This...
kr439.00 tax excl.
kr548.75 tax incl.
More
In stock, shipped today

Reference: TA018

Brand: MicroTec

Current clamp with BNC plug (60A AC/DC)

Review(s): 0
60A AC/DC current clamp with BNC connector and 2.5 meter long cable.The TA018 current clamp can measure currents from 10 mA up to 60 A with a switch-selectable high and low range. A simple pushbutton is included for zero adjustment when measuring DC current. The TA018  current clamp meets IEC 61010-1 CAT II 300V and is equipped with LED indication for...
kr889.00 tax excl.
kr1,111.25 tax incl.
More
In stock, shipped today

Reference: TA000

Brand: Pico Technology

Automotive Test Lead - 3m

Review(s): 0
The TA000 test lead has been custom made for automotive use with the PicoScope. Its long length (3 meters / approx 10 ft) allows the oscilloscope to be placed on the work bench away from the car being tested / repaired. A wide range of probes, clips and gators can be plugged into the 4mm connectors at the end of the cable. The cable is fully screened to...
kr249.00 tax excl.
kr311.25 tax incl.
More
In stock, shipped today

Reference: MA002

Brand: MicroTec

Multimeter Probes

Review(s): 0
The multimeter probes offer a quick and easy solution, where a permanent connection is not required. A test lead can be connected straight into the 4mm socket in the handle of the probe.
kr35.00 tax excl.
kr43.75 tax incl.
More
In stock, shipped today

Reference: BM319S

Brand: Brymen Technology

Brymen BM319s Automotive Multimeter

Review(s): 0
Brymen BM319s Automotive Multimeter incl. K-type temperature sensor and inductive pickup clip.The instrument is double insulated, equipped with high-efficiency fuses with control function and complies with IEC 1010-1 CAT II 1000V.
kr1,395.00 tax excl.
kr1,743.75 tax incl.
More
In stock, shipped today

Reference: TA002

Brand: Pico Technology

Picotech Multimeter Probes

Review(s): 0
The multimeter probes offer a quick and easy solution, where a permanent connection is not required. A test lead can be connected straight into the 4mm socket in the handle of the probe.
kr38.00 tax excl.
kr47.50 tax incl.
More
In stock, shipped today

Reference: TA037

Brand: Pico Technology

Coil-On-Plug HT Extension Lead

Review(s): 0
HT extension leads are the simple accessory that allow you to take accurate secondary ignition measurements on COP ignition systems.
kr329.00 tax excl.
kr411.25 tax incl.
More
In stock, shipped today

Reference: TA010

Brand: MicroTec

20:1 Attenuator

Review(s): 0
The TA010 has been designed to allow fuel injector and primary ignition waveforms to be measured using PicoScope oscilloscope products. The TA010 is a passive 20:1 attenuator. This means that a 20V signal at its input will appear as a 1V signal on the output. As the signal is attenuated, the TA010 allows voltages of up to 300 V to be measured. Please note...
kr389.00 tax excl.
kr486.25 tax incl.
More
In stock, shipped today

Reference: TA019

Brand: Pico Technology

Current clamp (600A AC/DC)

Review(s): 0
600A AC/DC current clamp with BNC connector.The TA019 current clamp is ideal for use with a PicoScope oscilloscope to display starter current waveforms, charging currents and for performing quick compression tests.
kr1,115.00 tax excl.
kr1,393.75 tax incl.
More
In stock, shipped today

Reference: TA034

Brand: Pico Technology

ATC / ATO fuse extension lead

Review(s): 0
Do you need to measure the current through a circuit but can’t find anywhere on the vehicle where you can connect your current clamp? Fuse extension leads are a simple accessory that can save you valuable time. Fuse extension leads are quick and easy to use: simply remove the fuse (of the circuit you wish to test) from your fusebox and replace it with a...
kr179.00 tax excl.
kr223.75 tax incl.
More
In stock, shipped today

Reference: MA100

Brand: MicroTec

Test leads with 4mm safety banana plug, set of 5 colors.

Review(s): 0
Test leads with 4mm safety banana plug at both ends, set of 5 colors (Red, black, yellow, green and blue).Can be used with all our probes, tips, clips and gators. Length: 1 meterMax. current: 15A
kr159.00 tax excl.
kr198.75 tax incl.
More
In stock, shipped today

Reference: TA167

Brand: Pico Technology

Current clamp - 2000A/200A (AC/DC)

Review(s): 0
This current clamp is suitable for measuring currents of upto 2000 A DC or 1500 A AC and is terminated in a BNC connector.
kr2,060.00 tax excl.
kr2,575.00 tax incl.
More
In stock, shipped today

Reference: TA162

Brand: Pico Technology

Flexible back-pinning Probes

Review(s): 0
These probes are designed for back-probing under the insulation of multi-plug terminals. The TA161 and TA162 have flexible bends to improve access to difficult areas. Each probe fits onto the 4mm plug of our BNC to 4mm test leads.
kr29.00 tax excl.
kr36.25 tax incl.
More
In stock, shipped today

Reference: MA101

Brand: MicroTec

Alligator Test Leads with large 45mm clips, length 50 cm, set of 2 x 5 colors

Review(s): 0
Heavy-duty test leads with 45 mm robust alligator clips that make it easy to connect the wire to test points, components, or other wires without the need for holding or soldering. The alligator clip ensures a strong connection and a reliable grip on the connection point
kr79.00 tax excl.
kr98.75 tax incl.
More
In stock, shipped today

Reference: TA189

Brand: Pico Technology

30A AC/DC precision current probe, BNC connector

Review(s): 0
The TA189 30A high-precision current probe is for applications requiring current measurement without the need to disconnect wiring, using closed-loop Hall effect technology to measure both AC and DC current with high stability over long periods of time.
kr3,421.00 tax excl.
kr4,276.25 tax incl.
More
In stock, 1-2 days delivery

Reference: TA168

Brand: Pico Technology

JCASE fuse extension lead

Review(s): 0
The TA168 JCASE fuse extension lead gives easier access to standard and low profile JCASE fuses. JCASE is a cartridge style fuse with female terminal design, providing both increased time delay and low voltage drop to protect high current circuits & handle inrush currents.
kr279.00 tax excl.
kr348.75 tax incl.
More
In stock, shipped today

Reference: TA398

Brand: Pico Technology

PicoBNC+ COP and signal probe

Review(s): 0
The TA398 COP and signal probe from Pico Technology is the easiest and fastest non-intrusive way to check coil-on-plug ignition coils and spark plugs. NOTE: This product is fitted with a PicoBNC+ interface, allowing it to be recognised by the software for auto-configuration.The product requires a PicoScope featuring the PicoBNC+ such as the PicoScope...
kr1,515.00 tax excl.
kr1,893.75 tax incl.
More
In stock, shipped today

Reference: TA004

Brand: Pico Technology

Small Crocodile/Gator Clips

Review(s): 0
The crocodile (gator) clips are fully insulated with a 4mm socket in the handle, offering an easy connection to a test lead. The toothed grip offers good contact on fine wire, with a 11mm jaw opening limit.
kr19.00 tax excl.
kr23.75 tax incl.
More
In stock, shipped today

Reference: TA035

Brand: Pico Technology

Mini fuse extension lead

Review(s): 0
Do you need to measure the current through a circuit but can’t find anywhere on the vehicle where you can connect your current clamp? Fuse extension leads are a simple accessory that can save you valuable time. Fuse extension leads are quick and easy to use: simply remove the fuse (of the circuit you wish to test) from your fusebox and replace it with a...
kr199.00 tax excl.
kr248.75 tax incl.
More
In stock, shipped today

Reference: TA473

Brand: Pico Technology

PicoBNC+ 60A AC/DC current clamp

Review(s): 0
The TA473 current clamp is ideal for use with PicoScope automotive oscilloscopes for measuring currents between 10 mA and 60 A. This enables the PicoScope to display current waveforms for fuel injectors and fuel pumps. NOTE: This product is fitted with a PicoBNC+ interface, allowing it to be recognised by the software for auto-configuration.The product...
kr2,185.00 tax excl.
kr2,731.25 tax incl.
More
In stock, shipped today

Reference: TA397

Brand: Pico Technology

PicoBNC+ secondary ignition pickup

Review(s): 0
Due to the high voltages involved in secondary ignition systems, it is not possible to make measurements by direct connection. Attempting to make a direct connection will almost certainly damage the measuring instrument. The TA397 is a capacitive pickup that simply connects around the insulation of an ignition circuit component such as a plug wire. This...
kr479.00 tax excl.
kr598.75 tax incl.
More
In stock, shipped today

Follow us on Facebook